Problem
Standby light flashing when Kitchen
Machine first plugged in.
The Kitchen Machine stops during
operation.
Standby light flashing rapidly.
The Kitchen Machine stops during
operation. Standby light is flashing
slowly.
Standby light off whilst machine plugged
in.
Display screen shows an alpha/
numerical error code.
When contacting customer care, you may be required to supply details of the software version. This can be found by pressing the menu
button and selecting "SETTINGS" then "VERSION".
5720000723 Iss 2 KCC90 Eng_Fre_Ger_Ital_Sp.A4..indd 25
Cause
Speed control not in the 'O' position.
Mixer head in the raised position or not
locked down correctly.
Overload protection or overheat system
activated.
Maximum capacity exceeded.
1 Heat shield removed or an outlet cover
removed.
2 Mixer head lifted.
3 Outlet attachment has exceeded its
maximum running time.
Kitchen machine has been left plugged in
for more than 30 minutes without being
operated and has gone into Standby mode.
Appliance not functioning properly.
25
Solution
Check and turn speed control to the 'O'
position.
Check Kitchen Machine head is locked down
correctly.
Unplug and check for obstruction or
overloading.
Turn the speed control to "O" and then restart.
If the machine will not operate, remove some of
the ingredients to reduce the load and restart.
If this still does not resolve the problem, unplug
and allow to stand for 15 minutes. Plug in and
reselect the speed.
If the machine does not restart following the
above procedure contact "customer care" for
further advice.
1 Fit heat shield or outlet cover. Turn the speed
control to "O" and then restart.
2 Lower mixer head. Turn the speed control to
"O" and then restart.
3 Turn the speed control to "O" and then
restart.
Press the Standby button once to reset.
Contact an authorised Kenwood Service
Centre. To find up to date details of your
nearest Kenwood Service Centre visit
www.kenwoodworld.com or the website
specific to your country.
23/11/2016 09:07