Kenwood KCC90 Serie Instructions page 20

to fit and use your splashguard assembly
The splashguard assembly consists of 2 pieces: the heat
shield and the splashguard.
The heat shield must be fitted during cooking
operations otherwise the machine will not operate
and "Fit heat shield" will be displayed. The heat shield is
to protect the mixer head from steam produced during the
cooking process.
The splashguard should not be fitted to the bowl unless used
in conjunction with the heat shield.
1 Raise the mixer head until it locks.
2 Push the heat shield upwards onto the underside of the mixer
head until fully located. The heat shield must never be
8
used without the rubber seal correctly fitted.
3 Fit the bowl onto the base.
4 Lower the mixer head.
5 Rest the splashguard on the bowl rim and then slide forward
until fully located .
9
• During mixing, ingredients can be added directly to the bowl
via the feed chute.
6 To remove the splashguard simply slide it away from the
appliance.
7 To remove the heat shield, raise the mixer head until it locks.
Remove the tool, then pull the heat shield downwards from
the underside of the mixer head.
Note: Only fit or remove the splashguard when the mixer head
is in the locked position.
5720000723 Iss 2 KCC90 Eng_Fre_Ger_Ital_Sp.A4..indd 20
8
9
20
23/11/2016 09:07