CAMPAGNOLA Mastiff Manuel D'utilisation Et D'entretien page 45

5 – USE OF THE TOOL
PROPORTIONAL CUT: The operator fully controls the cutting blade (14) opening and closing
movements. The blade (14) either moves or stops according to the operator's finger operating the trigger
(12). This mode guarantees the operators' maximum safety. Therefore, it is recommended to use such
mode for at least 5/6 days until the operator gains the necessary confidence.
100% AUTOMATIC CUT: The cutting blade (14) fully opens and closes automatically. It only requires a
light pressure on the trigger and allows to prune very quickly It is recommended to use it only after the
operator has become well trained.
70% AUTOMATIC CUT: The cutting blade (14) opens 70% and closes automatically thanks to a light
pressure on the trigger. This mode allows to prune faster than AUTO100. It is recommended to use it only
after the operator has become well trained.
40% AUTOMATIC CUT: The cutting blade (14) opens 40% and closes automatically thanks to a light
pressure on the trigger. This mode allows to prune in the fastest way. It is recommended to use it only
after the operator has become well trained.
IMPORTANT!
AUTO70 and AUTO40 modes allow to increase the blade opening for one cut by quickly pulling the trigger
and releasing it before the blade closes completely. If it were not enough, it would be possible to repeat
the operation till obtaining the widest one.
SERVICE: Checks the blade tightening adjustment. For the blade tightening adjustment operations see
par. 6.1.3.
• Put the branch to be cut between the blades, taking care of keeping the free hand and any other object away
from the tool.
• Press the trigger to start cutting. In any mode, if the trigger is released, the shear opens the blades even if the
pruning operation has not been fully carried out..
5.1.1 Display indications
According to the chosen mode by means of the selector , the display will show the following indications:
1
2
- For the Proportional, 100% Automatic, 70% Automatic and 40% Automatic mode:
1) Operating mode: MANUAL corresponds to the Proportional mode; AUTO100 to the 100%
Automatic mode; AUTO70 to the 70% Automatic mode and AUTO40 to the 40% Automatic mode.
2) Battery charge level
All manuals and user guides at all-guides.com
OFF
PROPORTIONAL
AUTOMATIC 100
AUTOMATIC 70
SERVICE
3
4
45 - 120