Publicité
Les langues disponibles
Les langues disponibles
Install Water Tank (P) (if equipped):
• A factory installed water tank is available in some
regions. An optional water tank kit is available for all
regions.
• If water tank was previously installed on machine, read
these instructions to verify that installation is correct. Fol-
low all WARNINGS for installation and use of the Water
Tank.
• Verify the contents of the Water Tank Kit See Diagram at
right.
. Temporarily remove the right hand (same side of ma-
chine as engine starter rope) NUT from Lifting Eye (O).
See diagram at right.
. Install CLAMP supplied in Water Tank Kit (P), and then
reinstall the NUT. See diagram at right.
3. Torque as specified below, and diagram at right.
Torque Lifting Eye NUT to 83 N-m (61 lb-ft) mini-
Torque NUT as specified, else failure of LIFTING EYE
(O) could occur. Injury or death could occur if LIFT-
ING EYE fails while lifting machine.
8
NOTICE
mum.
WARNING!
ASSEMBLY
Publicité
