Publicité
Les langues disponibles
Les langues disponibles
GB
Fig.8
Replacing cutting line.(Fig.9)
Stop the engine, follow the sequence below.
Fig.9
WARNING!
Never use non-recommended cutting attachments and appropriate guards and their
location. The non approved cutting attachments may cause serous injure during working.
Assembly the two-piece tube (Fig.10)
Put the lower shaft (2) into the shaft coupling and concurrently pull out the locking pin (1).
Slide the lower shaft in as far as it will go and let go of the locking pin. The locking pin
must engage into the opening (3) located laterally in the lower shaft. Of necessary,
slightly move the lower shaft to-and-fro until the locking pin safely locks in place. Then
tighten the fly nut (4).
13
Publicité
