Bestgreen BCI33UF Traduction Des Instructions D'origine page 72

WARNING!
Please make sure the cutting head has been assembled correctly before use!
Nylon head
Release the nut(Fig.6)
Line up the two holes of flange and shield, use one screw driver to hold the flange as
below and turn the socket wrench clockwise, the nut will be released.
Fit the Nylon cutting head.(Fig.7)
Remove another shield after release the nut. Still hold the flange, take the Nylon cutting
head on the shaft and rotate counter-clockwise, the Nylon cutting head is fitted.
Release the Nylon cutting head.(Fig.8)
Use screw driver to hold flange and then rotate the Nylon cutting head clockwise till it is
well fixed, it will be replaced.
Fig.5-1
Fig.6
Fig.7
12
GB
Fig.5-2