Publicité
Les langues disponibles
Les langues disponibles
"GLACIER PRO" PLOW FRAME
KIT PN 2879103
PUSHFRAME INSTALLATION AND REMOVAL
If you have purchased a hydraulic lifting system, refer to installation manual supplied with the hydraulic lift system.
N OTE: The first installation requires you to adjust
the height of the kickstand (#49) of ground clearance
of your vehicle. It may be necessary to repeat the
exercise if you add accessories to your vehicle that
affect the ground clearance.
N OTE: If the vehicle is too low, you may need to
adjust the vehicle height by changing the adjustment
of the front suspension. Refer to vehicle manual for
the adjustment method.
HEIGHT ADJUSTMENT OF THE KICKSTAND:
The kickstand (#49) must maintain the pushframe
raised so that the opening of the lower attachment
plates is of equal height with the axes of connector of
the vehicle. Tighten or loosen the kickstand shoe
(#56) and tighten the nut (#15) when the height is
adjusted.
Axes of Connector
7515233
A-7515233 Rev. A
Opening
PUSHFRAME INSTALLATION:
1. Move the vehicle towards the pushframe assembly.
Make sure to align the vehicle with the pushframe.
2. Make sure the vehicle is fully engaged in the
attachment plates on both sides.
3. Raise the hook up (#43) by pulling up towards the
vehicle until the opening of the hook and close to the
attachment superior tube.
If the hook does not engage completely, check that
the axes of the mounting plate are well positioned in
the bottom opening perhaps accumulation of snow or
ice could block the movement of moving parts.
4. Once the pushframe is attached to the vehicle, the
kickstand should be slightly raised. The kickstand
shoe should not touch the ground. If it touches the
ground, the kickstand shoe is not adjusted to the
proper height. Repeat steps of adjusting the height of
the kickstand.
5. Connect the hook of the winch onto the winch link
(winch link supplied in mount plate kit).
- 11-
Printed in China
Publicité
