Publicité
Les langues disponibles
Les langues disponibles
"GLACIER PRO" PLOW FRAME
KIT PN 2879103
FRAME ASSEMBLY INSTRUCTIONS
PIVOT ASSEMBLY:
1. Insert the
plow leveling springs (#35) into the
(2)
locations provided for this purpose (#28).
2. Position the pushframe (#28) into the middle part of
the pivot (#37). Insert the pivot pin (#61) from
above.
WARNING: The pivot pin (#61) must be aligned to
fit between the plow leveling springs (#35) and then
into the bottom hole of the pivot (#37).
3. Insert the
4 mm dia X 30 mm
two ends so it can not be removed.
7515233
A-7515233 Rev. A
cotter pin (#4) and fold the
- 8-
MANUAL ANGULATION MECHANISM
ASSEMBLY:
N OTE: If you have purchased a hydraulic system
for angulation, do not install the manual angulation
mechanism. You must install the hydraulic angle at
that time by following the instructions provided with
the hydraulic system of angulation.
1. Position the mechanism and insert the angle bar pin
(short) (#58) into the mounting holes of the
pushframe (#28) and the inner angle bar (#31).
2. Insert the
3 mm dia X 25 mm
two ends so it can not be removed.
3. Position the other end of the mechanism and insert
the angle tube pin (long) (#59) into the mounting
holes of the pivot (#37) and the outer angle tube
(#30).
4. Insert the
3 mm dia X 25 mm
two ends so it can not be removed.
cotter pin (#3) and fold the
cotter pin (#3) and fold the
Printed in China
Publicité
