Publicité
Les langues disponibles
Les langues disponibles
7. Remove shipping screws from top of unit and also on both sides by the base if installed. These screws will be
needed to re-install later(See FIG.5)(See FIG.5)
8. With the aid of an assistant, hold the cabinet while pulling on the base pan handle (see FIG. 4), and carefully
remove the air conditioner from cabinet.
9. Add two foam inserts to holes in top of cabinet where shipping screws were removed from. (See FIG.6)
10. Heavy duty models (28,000BTU) come with internal shipping packaging.
THIS PACKAGING AND PLASTIC TIES MUST BE REMOVED PRIOR TO INSTALLING THE AIR CONDITIONER
BACK INTO THE CABINET. (See FIG.7)
11. Remove plastic wrapping from all points on power cord.
FIG.5
shipping
screws
2
Install Top Angle Rail and Side Retainers
1. Remove adhesive strip coating from foam gasket. Attach adhesive side of gasket to bottom of top angle rail. Insert 4
screws from inside of cabinet and secure to top angle rail.
2. From inside of cabinet insert 3 screws to attach each side retainer as shown
in Fig. 8. Attach side retainers with flat side against cabinet and angled edge toward
rear of cabinet.
3
Assemble Window Filler Panels
1. Place cabinet on floor, a bench, or a table.
2. Slide "I" section at end of window filler panel into side retainer on each side of the
cabinet (see FIG. 9 and FIG.10).
3. On each side of cabinet, insert top and bottom legs of window filler panel
frame into channel in the top and bottom angle rails.
4. Insert a 7/16" locking screw and flat washer into hole on top leg of each window filler panel (see section 6). Do not
totally tighten. Allow leg to slide freely. Screws will be tightened after Section 6.
Top window filler
FIG.9
panel leg
Bottom window
filler panel leg
4
Installation Instructions
Shipping Packaging
FIG.6
WINDOW FILLER
PANEL
SIDE RETAINER
Plastic tie
TOP VIEW
FIG.10
AIR CONDITIONER
CABINET
"I" SECTION
FIG.7
FIG.8
Top angle rail
Foam Gasket
PLASTIC
FRAME
LOCKING
SCREW HOLE
WINDOW
FILLER
PANEL
Publicité
