Publicité
Les langues disponibles
Les langues disponibles
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Assembly
Assemble the handle (1) to the fuel tank (12) with the provided screws.
4.3- Hose assembly
Important: use only a PVC suction ringed hose or other hose with similar quality (not included).
not supplied.
Note: the hoses are
Assemble the intake hose joint and the intake hose (suction hose) to the water pump.
Assemble the outtake hose joint and the delivery hose (discharge hose) to the water pump.
1. Insert the couplings into the suction and discharge
hoses
2. Use the clamps and tape (not supplied) and tighten
firmly.
Then screw the hose couplings to the pump suction
inlet and discharge port.
3. Screw assembly to pump inlet (4) for suction hose
and pump outlet (3) for discharge hose.
4. Insert strainer in suction hose.
Note: Make sure the washer is properly fitted on the intake hose coupling.
If the washer of the suction hose is loosened, or the hose buckle is lost or damaged, the
water will not be pumped properly due to air leakage.
4.4- Before starting engine
Note: Check that both suction hose and discharge hose are properly assembled.
Note: Before each use, ensure that the fuel tank is fully filled in. Refill if necessary
1. Fill water into the self-priming port [2] to make the intake hose and the water pump full of water.
Proceed as follows:
1. Remove cap
IMPORTANT: A continual idling or operation without water in the pump will lead to its damage.
So before starting the engine, please make sure that the pump has been refilled water.
2. Fill in with water
3. Replace cap
- 22 -
Publicité
