Publicité
Les langues disponibles
Les langues disponibles
What to do if ...
Problem
The cooking zones are not func-
tioning.
The cooking zones cannot be se-
lected / Appliance does not react to
the control panel input
The residual heat indicator is not
displaying anything
Er03
is displayed
Er21
is displayed
Er25
is displayed
(only for 10 seconds)
Er40
is displayed
3
In the event of any other fault codes that arise,
disconnect the appliance from the electrical
supply for a few seconds. (Take out the fuse
from the house's wiring system.) If the fault is
displayed again, please call the Customer
Care Department and inform them of the fault
code.
If you are unable to remedy the problem by fol-
lowing the above suggestions, please contact
your dealer or the Customer Care Department.
1
Warning! Repairs to the appliance are only to
be carried out by qualified service engineers.
Considerable danger to the user may result
from improper repairs.
3
If the appliance has been wrongly operated,
the visit from the customer service technician
or dealer may not take place free of charge,
even during the warranty period.
Possible cause
No cooking zone selected
More than 10 seconds have passed
since the appliance was switched
on
The child safety device is activated
l
The sensor fields are partly covered
by a damp cloth or with liquid
Safety cut-out has been triggered
The cooking zone was only on for a
short time and is therefore not hot
Several sensor fields were touched
at the same time
Safety cut-out due to overheating
Appliance is incorrectly connected
The overvoltage protector has been
activated (for an incorrect connec-
tion see above Er25 or for over-
heating of the electronic
components see Er21)
Remedy
Select cooking zone within 10 sec-
onds of switching on (Decimal point
lights up)
Switch on the appliance again.
Select cooking zone within 10 sec-
onds of switching on
Deactivate the child safety device
(See section "Child safety device")
Remove the cloth or the liquid
Switch on the appliance again
If the cooking zone is supposed to
be hot, call the Customer Service
Department.
Only touch one sensor field
Let the appliance cool down.
Remove cookware.
Disconnect the appliance from the
electrical supply and have it con-
nected properly
Separate the appliance from the
mains for a few minutes (remove
the mains fuse).
Let the appliance cool down.
29
Publicité
