Agilent Technologies Turbo-V 81 PCB 24 Vdc Mode D'emploi page 164

16 Instructions for Use
General Information
General Information
This equipment is intended for professional use. Prior to using the
equipment, the operator must carefully read this instruction manual
and any other additional information provided by Agilent. Agilent
declines all responsibility which may become as the result of the total
or partial misinterpretation of the information provided in the
documentation, by the improper use of the equipment by untrained
personnel or by the use of the equipment by unauthorized personnel
or not in compliance with specific national norms. The Turbo-V 81
PCB controller is a microprocessor-controlled frequency converter
made up of solid state components and capable of autodiagnostic and
auto-protection functionality. It incorporates the circuitry needed for
the automatic operation of Turbo-V 81 series pumps. The Turbo-V 81
series pumps are driven by the controller (in a 10-step procedure)
during the start-up phase that also checks the voltage and current
according to the speed reached by the pump. Auxiliary connectors
render the commands needed to start and stop the pump from
remote, the signals that indicate the operating state of the pump and
the locking commands (for pressure switches, water flow control
switches, etc.) available. The controller must be provided with 24
Vdc.
In the next sections you will find all the information needed to
guarantee operator safety during the use of the equipment. Detailed
information is provided in the Appendix entitled "Technical
Information".
164/208 Turbo-V 81 PCB 24 Vdc Controller User Manual / 87-900-121-01 (D)