Suntec Wellness KLIMATRONIC 11580 HEAT SUPREME Mode D'emploi page 13

Unit Layout
Electronic version (HEAT SUPREME)
1. On/off switch
2. LCD display
3. Power light indicator
4. Function buttons
5. Metal grid
6. Rails
Remove Packaging
Please read all the instructions before using this heater
1.
Take out the heater from gift box.
2.
Remove the polyfoam and polybag.
3.
Inside are: 1 bag with 1 Mounting Support, 4 screws, 4 Mounting Anchors for wall mounting
4.
4 screws to fix the rails. Save the packaging for storage when the heater is not been used or in
summer season.
Racks Installation
Screw the rails on the heater using the 4 special screws. It has to be done before the installation of the heater
on the wall.
Installation
Heater has to be mounted minimum 0.7m from the floor and no object (e.g. Shelf) should be placed within 1m
from the top of the heater.
We recommend installing the heater in the bathroom area at least 0.6m away from shower OR bathtub as shown
in the picture (volume 3). The figure 0.6m is a suggested distance; the actual distance from the shower and
bathtub should follow national standard in each country
Once the racks are mounted, you can start the following steps to install the heater on the wall.
1. please use the upper wall bracket as a template and mark two drill holes on the wall (approx. 1.5 m from
the floor) using a pencil. Please make sure that both holes are at the same height.
2. please drill both drill holes.
3. please hammer the dowels into the drill holes.
4. please screw the wall bracket tightly.
5. please mount the radiator to the wall bracket.
6. Please mark the positions of the drill holes (left and right) of the lower wall brackets on the wall using a
pencil. Please remove the radiator from the wall bracket.
7. Please drill both drill holes.
8. Please hammer both remaining dowels into the drill holes.
9. please fix the radiator to the wall bracket and screw the two remaining screws to the lower wall bracket.
Operation
Please read all the instructions before using this heater.
1.
Please make sure the power switch is on "OFF" position.
2.
Plug the power cord into a suitable electrical outlet. (Rating is not less than 10A)
3.
Please press the main switch to "ON". Press and hold the "MODE" and "SET" buttons for 10 seconds to
reset the programming (this step only needs to be done during the initial start-up for switching on).
4.
Please use the "SET", "+" and "-" buttons to set the current time and day. You can also use these buttons
to set the weekly program for switching the unit on and off, as well as the target temperature.
Example: Programming on Sunday "Sun", switch-on time "ON" 7:30 h, switch-off time "OFF" 10:00 h,
target temperature 20°C
5.
Press the button "MODE" to select the operation mode:
• Manual mode:
The display shows a hand symbol. The preset target temperature is 22°C.
Please use the "+" and "-" keys to set your desired target temperature to
either 5°C (anti-frost function) or 10°C-32°C. If the room temperature is lower
7. Built-in Handle
8. Mounting Hole
9. Mounting Support
10. Screws
11. Mounting Anchor for wall mounting
12. Screws for rails installation
13. Lower wall mounting support
14. Small screw for lower wall mounting