Publicité
Les langues disponibles
Les langues disponibles
Spark Plug Removal and Inspection
1� Place and park the vehicle on a level ground�
2� Remove the spark plug cap. ( R emove the rear access cover
before removing spark plug on the cylinder head )
3� Remove the spark plug cap�
4� Use the spark plug socket and wrench from the tool kit to
remove the spark plug�
5� Check the spark plug gap ( A ) using a thickness gauge. Adjust
the gap if necessary.
NOTE:
Specified spark plug: CR8EK ( N GK )
Spark plug gap: 0.026 in ~ 0.030 in ( 0 .65 mm ~ 0.75 mm )
6� Clean the gasket surface. Wipe off any grime from the threads.
7� Install spark plug and tighten to specified torque.
Spark Plug Torque: 11.05 ft-lb. ( 1 5 N•m ) �
NOTE: If a torque wrench is not available when you are installing a
spark plug, a good estimation of the correct torque is to tighten the
spark plug by finger first, then use tool to tighten 1/4 to 1/2 turn.
8� Install the spark plug cap�
9� Install the rear access cover�
MAINTENANCE PROCEDURES
153
Publicité
