Publicité
Les langues disponibles
Les langues disponibles
1800115362 GV52XX TEFAL:110x154
Description
1.
Steam control dial
2.
Temperature setting mark
3.
Iron temperature adjustment button
4.
Thermostat light
5.
Iron rest
6.
Boiler (inside the base-unit)
7.
Lock system (according to model)
8.
Power and steam cord storage compartment
• Your steam generator is equipped with a retaining hoop which locks the iron on its base for ea-
sier transport and storage:
- Locking
- Unlocking
• To carry your steam generator by the iron handle:
- Place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it
locks into place (audible click)
- Grasp the handle of the iron to carry your steam generator
Preparation
What water to use ?
• Your iron has been designed to operate using untreated tap water. However, in some
coastal regions, your water may have a high salt content. In this case, only use de-
mineralised water.
• Types of water not to use: Heat concentrates the elements contained in water du-
ring evaporation. The types of water listed below may contain organic waster, mi-
neral or chemical elements that can cause spitting, brown staining or premature
wear of the appliance: water from clothes dryers, scented or softened water, water
from refrigerators, batteries, air conditioners, rain water, boiled, filtered or bottled
water. These types of water should NOT be used in your TEFAL steam generator.
Also only use distilled or demineralised water as advised left.
• Ironing Boards: Due to the powerful steam output, a mesh type iorning board must
be used to allow any excess steam to escapte and to avoid steam venting side-
ways.
• Place your steam generator on a flat, stable, heat-resistant surface.
• Check that your appliance is unplugged and cold.
• Unscrew the boiler cap.
• Using a water jug, fill with maximum 1 litre of water. Fill the boiler, taking care that the water
does not spill over fig.4. If this occurs, remove the excess water.
• Replace the boiler cap, screwing on firmly, but not over tight.
Using your steam generator
• Completely unwind the power cord and the steam cord from its storage space .
• Tilt the locking ring of the iron forwards to release the safety catch.
• Plug in your steam generator to an earthed socket.
• Press the on/off luminous switch. It comes on and the boiler heats up.
• After approximately 8 minutes or when the steam ready indicator light comes on (ac-
cording to model), the steam is ready
• During ironing the iron's thermostat light and the steam indicator (according to
model) will go on and off according to the temperature control.
5
Locking system for retaining the iron on the base
- fig.1
- fig.2
-
fig.1.
-
fig.5.
16/06/09
15:16
9.
Steam cord
10.
Power cord
11.
Boiler cap
12.
Illuminated on/off switch
13.
Steam ready indicator light (according to model)
14.
Steam flow adjustment dial
(according to model)
Lock system (depending on model)
-
fig.3.
If your water is very hard
(check with your local
water authority) it is pos-
sible to mix tap water
with store-bought distil-
led or demineralised
water in the following
proportions : 50% untrea-
ted tap water, 50% distil-
led or demineralised
water.
Page 5
Filling the boiler
The first time the ap-
pliance is used, there
may be some fumes
and smell but this is
not harmful. They will
not affect use and will
disappear rapidly.
Publicité
