Hayward GOLDLINE Aqua Rite Pro LS Guide De L'utilisateur page 31

Input power to the AquaRite Pro LS must be 230 V / 50Hz. Refer to the wiring label on the AquaRite Pro LS as well as
the diagram below for correct wiring connections.
Electrolytic Cell and Flow Switch:
The electrolytic cell and flow switch cables are terminated with connectors which plug into the AquaRite Pro LS for easy
attachment and removal. The door of the AquaRite Pro LS must be open and the front panel removed to access the cell
cable and flow switch connectors. Route the flow switch cable through one of the knockouts. A cutout in the enclosure is
provided for the cell cable. The diagram below shows the location of these connections.
AQL-CHEM Chemistry Kit
Plug the connector from the AQL-CHEM into the designated connector on the AquaRite Pro LS PCB as shown below. For
detailed installation and operation information, refer to the AQL-CHEM instructions.
Page 14 of 16
TYPICAL 230 V / 50Hz WIRING
AquaRite
Pro LS
N
L
PCB
Flow Switch
Connector
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
AquaRite
Cell Connector
Connector for
AQL-CHEM
Pro LS
®
230 V / 50Hz
FROM SUBPANEL
Rev. D