Hayward GOLDLINE Aqua Rite Pro LS Guide De L'utilisateur page 29

INSTALLATION
Installation must be performed in accordance with Local codes.
Preparing Pool Water
Refer to page 4 for recommended chemical levels. The pool's chemistry must be balanced BEFORE activating the
AquaRite Pro LS. NOTE: If the pool does not have new water, add 1 liter of metal remover and 1 liter of non-copper
based algaecide to the pool, per manufacturer's instructions. This ensures a quick, troublefree transfer to the AquaRite
Pro LS system.
Mounting the AquaRite Pro LS Control
The AquaRite Pro LS is contained in a raintight enclosure that is suitable for outdoor mounting. The control must be
mounted a minimum 3.5 meters horizontal distance (or more, if local codes require) from the pool/spa.
The control is designed to mount horizontally on a flat surface with the knockouts facing downward. Because the
enclosure also acts as a heat sink (disperses heat from inside the box), it is important not to block the four sides of the
control. Do not mount AquaRite Pro LS inside a panel or tight enclosed area.
If an AQL-CHEM kit will be used, take into consideration the space necessary for mounting the unit as well as running
the plumbing lines from the AQL-CHEM's probe cell to the pool plumbing. Refer to the AQL-CHEM manual for specific
mounting instructions.
Plumbing
Ensure that the AquaRite Pro LS installation does not constitute a cross connection with the local potable water supply.
Consult local plumbing codes.
The AquaRite Pro LS is packaged with a flow switch that installs into the supplied 50 mm saddle clamp. The chlorinator
cell, sold separately, installs into the supplied 50 mm cell unions.
The flow switch and cell should be plumbed in the return line to the pool/spa. The preferred installation is after
(downstream) all the pool equipment (filter, heater, solar, etc.). For proper plumbing, refer to the overview diagram above.
Page 12 of 16
ELECTRICAL
230 V / 50Hz
LINE
POWER
FILTER
PUMP
FROM FROM
POOL
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
AquaRite
BOX
LOAD
HEATER
SOLAR
or
SYSTEM
HEAT
PUMP
FLOW
SWITCH
SPA
Pro LS
®
ELECTROLYTIC
CELL
IN-FLOOR
CLEANER
TO
SPA
TO
POOL
Rev. D