Husqvarna DE 130 H Manuel D'utilisation page 13

5. Push the 2 filter purge buttons at the same time.
X 3-5
X 3-5
6. Do step 5-6 5 times.
CAUTION:
product make vacuum between each
button push.
If the suction is not sufficient after this procedure, it is
necessary to clean the prefilter with water. Refer to
clean the prefilter with water on page 16 .
To install a new Longopac bag cassette
CAUTION:
you install a new Longopac cassette. Refer
To do a filter purge procedure on page
to
12 .
1. Put the Longopac cassette around the inner edge of
the Longopac holder.
2. Remove the 4 straps after you put the Longopac in
the holder.
3. Pull the inner layer of the Longopac cassette up (A)
and fold it into the holder (B).
A
2002 - 003 - 30.06.2023
It is important to let the
To
Clean the prefilter before
4. Attach the Longopac holder to the rear part of the
container (A). Then attach the Longopac holder to
the sides and to the front of the container (B). Push
the Longopac holder up until you hear a solid click.
A
5. Make sure that the Longopac is sealed.
6. Pull the outer layer of the Longopac cassette down.
B
B
13