Husqvarna DE 130 H Manuel D'utilisation page 20

Error codes
Error
Error
code
HEPA filter miss-
2
ing.
Low supply volt-
3
age.
High supply volt-
4
age.
Main Pressure
5
Sensor Error.
PCBA tempera-
6
ture too high.
7 Fan malfunction.
One wire com-
9 munication not
detected.
Warnings on the control panel
CAUTION:
if the red light comes on. If the initial solution
does not remove the error, speak with an
20
Description
Product shuts down/does not
start.
+ Warning light on HMI.
+ HEPA symbol on HMI.
Low performance (low air flow/
vacuum).
Product shuts down/does not
start.
+ Warning diode light on HMI.
Prefilter light flashes red.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Do not operate the product
Probable cause(s)
HEPA filter is missing or dam-
aged.
Too low voltage in grid/power
supply.
Too high voltage in grid/power
supply.
Wrong battery used.
Vacuum hose is disconnected
or blocked.
Control unit is damaged.
Too high ambient temperature.
Fan is damaged or disconnec-
ted.
Control unit is damaged.
Cable disconnected or dam-
aged.
approved service agent before you operate
the product again.
Action(s)
Assemble or replace
the HEPA filter.
Make sure correct
grid/power supply is
used.
Make sure correct
grid/power supply is
used.
Use correct battery.
Speak to an ap-
proved service agent.
Do not use the prod-
uct outside specified
temperature range.
Speak to an ap-
proved service agent.
Speak to an ap-
proved service agent.
2002 - 003 - 30.06.2023