Publicité
Les langues disponibles
Les langues disponibles
4. Push the On/Off button to start and stop the
operation.
5. To stop the operation, push the On/Off button. The
button goes off when you stop the operation.
6. Push the "0" on the main switch to deactivate the
product.
7. Disconnect the product from the power socket.
Hour meter
The hour meter shows how many hours the engine has
been in operation. Refer to
for the position of the hour meter.
Auto pulse function
The auto pulse function cleans the filters. The auto
pulse function is on when you start the product and
during operation. The auto pulse function is also on for
1 cycle after you stop the product. It is recommended
to operate the product with the auto pulse function on.
For some operations, it is necessary to stop the auto
pulse function. Refer to
function on page 12 .
12
Product overview on page 3
To stop and start the auto pulse
To stop and start the auto pulse function
1. Push the auto pulse button.
2. Make sure that the green LED indicator goes out.
Push the auto pulse button again to start the auto pulse
function. Make sure that the green LED indicator comes
on.
To do a filter purge procedure
It is necessary to do a filter purge procedure in these
situations:
•
Before a work stop or at the end of each work day.
•
When the suction is not sufficient.
•
Before you install a new Longopac bag.
•
When the prefilter clogged alarm starts. Refer to the
instructions on the decal on the prefilter cover.
1. Stop the product and make a short work stop to let
the dust particles set in the Longopac bag.
2. Start the product. Refer to
product on page 11 .
3. Close the air intake with the air intake plug or the
intake valve to make vacuum.
4. Wait 5 seconds until there is vacuum.
To start and stop the
2002 - 003 - 30.06.2023
Publicité
