English
PROBLEM
Nailer operates, but no nail is driven.
Weak drive.
Slow to cycle.
Drives too deep.
Skipping nails.
Intermittent feed.
Nails jam.
Driven nail is bent.
Battery cannot be installed
2. Charger
PROBLEM
The charge indicator lamp is rapidly
fl ickers purple, and battery charging
doesn't begin.
The charge indicator lamp blinks red,
and battery charging doesn't begin.
Battery usage time is short even
though the battery is fully charged.
32
CHECK METHOD
Magazine is dirty.
Check for a jam.
Driver blade worn or damaged?
Ribbon spring weakened or
damaged?
Nail feeder damaged?
Check for proper nails.
Check position of nailing depth
adjustment adjuster.
Driver blade worn?
Compressed air pressure has
become low.
Damaged internal electronics.
Check position of nailing depth
adjustment adjuster.
Check for proper nails.
Nail feeder damaged?
Ribbon spring weakened or
damaged?
Driver blade worn or damaged?
Check for proper nails.
Driver blade worn or damaged?
Attempting to install a battery other
than that specifi ed for the tool.
CHECK METHOD
The battery is not inserted all the way. Insert the battery fi rmly.
There is foreign matter in the battery
terminal or where the battery is
attached.
The battery is not inserted all the way. Insert the battery fi rmly.
The battery is overheated.
The battery's life is depleted.
CORRECTION
Blow and wipe clean the magazine.
Clear a jam (refer to page 28).
Contact metabo HPT for inspection.
Replace ribbon spring.
Replace nail feeder.
Use only recommended nails.
Readjust according to page 27.
Contact metabo HPT for inspection.
Contact metabo HPT for inspection.
Contact metabo HPT for inspection.
Readjust according to page 27.
Use only recommended nails.
Replace nail feeder.
Replace ribbon spring.
Contact metabo HPT for inspection.
Use only recommended nails.
Contact metabo HPT for inspection.
Please install a multi volt type battery.
CORRECTION
Remove the foreign matter.
If left alone, the battery will
automatically begin charging if its
temperature decreases, but this may
reduce battery life. It is recommended
that the battery be cooled in a well-
ventilated location away from direct
sunlight before charging it.
Replace the battery with a new one.