Publicité
Les langues disponibles
Les langues disponibles
FORM FEED MENU
Menu
FEEDING MEDIA
PH.MAIN MENU
Menu
#START MAINTENANCE
>
#MAINTENANCE
>SPITTOON CASE/UNIT
#CAP CLEANING
>
#SHEETMOUNT CLEANING
>
#INK SYSTEM OPT
>STORE INK SYS
#SERVICE TUBE SELECT
>87654321
#RESEAT PRINTHEAD
>
#WASH PRINTHEADS
>
PRINTER MENU
Menu
#CONFIG PRINT
>
#ERROR LOG PRINT
>
#HISTORY PRINT
>
ADJUST MENU
Menu
#NOZZLE PRINT
#EXECUTE
#PRINT HEAD ADJUST
#EXECUTE
#EDGE SENSOR ADJUST
#EXECUTE
SETUP MENU
Menu
#LANGUAGE
>JAPANESE
#TIME ZONE (GMT+)
>YY/MM/DD HH:MM ZZZ
#LENGTH UNITS
>MILLIMETER
#TEMPERATURE UNITS
>CENTIGRADE
#BEEP(UNCAP CARRI)
>ON
#BEEP(TUR TIMEOUT)
>ON
#BEEP(INK ERROR)
>ON
#BOOT VERSION
*X.XX
#PRINTER FW VER
*X.XX_YY
#MAIN PCA VER
*XXXXX
44
While you keep pressing the
key, the printer feeds media. (When cut-sheet media is used, the printer ejects
the media.)
Launch the start maintenance guidance.
Execute the various maintenance items.
The carriage moves to the maintenance area so that the capping unit can be cleaned periodically.
Execute sheet mount cleaning.
Execute the service (cleaning) operation.
Select the tube when performing #INK SYSTEM OPT.
Used to check the print head.
To prevent the nozzle from clogging, this function is provided to fill the cap with ink so that the print head
(nozzle surface) is soaked in the ink.
Used to print the printer information and operation panel setting information.
Used to print the error log information saved in the printer.
Used to print the ink system cleaning status and the print head replacement log saved in the printer.
Print a pattern to check print condition such as missing dots, and set the clogged nozzle numbers based on the
print results.
Print a head position adjustment pattern, and enter the head position adjustment value and the L to R
adjustment value based on the print results.
Print a sensor position adjustment pattern and enter the adjustment value for the media horizontal direction
(side direction) based on the print results.
Select the language of messages used for LCD.
Select a time zone.
Select a length unit.
Select a temperature unit.
Set whether to emit a warning beep in the state below.
- The print head is dislocated from the cap in the daily maintenance or head height adjustment.
- The print head cannot be capped due to a media jam error during printing.
Set whether to emit a warning beep when a take-up (TUR) timeout has occurred.
Set whether to emit a warning beep when an ink error has occurred.
Displays the BOOT version.
Displays the system firmware version.
Displays the version of the IPB board.
Outline of functions
Outline of functions
Outline of functions
Outline of functions
Outline of functions
Publicité
