Oki IP-7700-26 Guide De Référence Rapide page 36

5
# N O Z Z L E P R I N T
# E X E C U T E > O K ?
Press the key.
6
# N O Z Z L E P R I N T
[ E X E C U T I N G
7
Check for missing dots and incorrect print.
The following pattern is printed.
- Nozzle print sample
No line is missing and
the printout is correct
YES
Mark for the last nozzle (nozzle 508)
Check that nozzle print is complete
up to the right of this mark.
No line is bent and the
printout is correct
YES
If the spaces between
the lines are even, no line
is bent.
Check that there are no missing or bent lines.
If missing or bent lines are found with the nozzle print,
perform the normal cleaning.
If missing or bent lines remain after several normal
cleanings, set [NOZZLE MAP] with the procedure
below.
Nozzle map setting
1
# N O Z Z L E P R I N T
# E X E C U T E
Press the , key several times to select
nozzle map.
Up to 10 nozzles can be set with nozzle map for
each print head.
Missing lines are found
NO
Example when lines for nozzles 224
and 344 are missing in the printout.
The numbers of the nozzles for
which nozzle map has been set
are written in this area.
Bent lines are found
NO
If there are uneven
spaces between lines,
some lines may be bent.
Example: Bent lines are found
2
# N O Z Z L E P R I N T
# N O Z Z L E M A P 0 1 y 4 > 0 0 0
Press the key.
Here, nozzle map 01 is set for print head Gy4.
3
# N O Z Z L E P R I N T
# N O Z Z L E M A P 0 1 y 4 [ 0 0 0
Select the digit with the
value using the ,
4
# N O Z Z L E P R I N T
# N O Z Z L E M A P 0 1 y 4 [ 2 2 4
Press the key.
5
# N O Z Z L E P R I N T
# N O Z Z L E M A P 0 1 y 4 > 2 2 4
The setting is complete.
- The numbers of the nozzles for which nozzle map
has been set are indicated on the nozzle print
pattern printout.
, key and set the
key.
35