Publicité
Les langues disponibles
Les langues disponibles
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1
(not supplied) is required before use.
1
To enable the steering wheel remote
control, select [STEERING] [EDIT CUSTOM]
to make the registration.
When the registration completes, the steering
wheel remote control becomes available.
Notes on installing the connection cable
RC-SR1 (not supplied)
• Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper
connection may damage the unit.
• Depending on the type of car, be sure to insulate
the unused leads with electrical tape for safety.
• Do not connect this cable when the steering wheel
remote control is not used.
• Consulting the dealer or an experienced
technician for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set
[STRG CONTROL] in [STEERING] to [PRESET].
Installation
Removing the trim ring and the
mounting sleeve
Before installing the unit, remove the trim
ring and the mounting sleeve from the
unit.
1
Pinch both edges of the trim ring ,
then pull it out.
2
Insert both release keys until they
click, and pull down the mounting
sleeve , then pull up the unit to
separate.
Face the hook inwards.
17
GB
Publicité
