Clatronic MSS 436 CB Mode D'emploi & Garantie page 39

Before initial operation
• Unpack the device carefully and remove all packaging materials.
Caution! Do not allow small children to play with the foil.
Danger of suffocation!
• Select a suitable location for the appliance, such as a dry, fl at, non-slip surface
on which it is easy to operate the machine.
Power supply
• Insert the mains plug into a correctly installed 230 V, 50 Hz power socket.
• Ensure that the voltage is the same as that indicated on the model identifi cati-
on plate.
Kitchen Knives
1. Place the device on a fl at surface and hold the housing in your hand so that
you can press the button with your thumb (see illustration 1).
2. Turn the guide cap until the "knife" symbol is in line with point b on the device.
3. Press the on/off button. The button has to be held in this position.
4. Insert the knife blade either in the right-hand or left-hand blade guide mecha-
nism and pull the knife towards you at an even speed. Sharpen the right-hand
side of the knife (illustration 1) on the right-hand guide mechanism and the
left-hand side (illustration 2) on the left-hand guide mechanism.
5. To switch off the device release the on/off button and then remove the mains
plug from the socket.
1. Place the device on a fl at surface and hold the housing in your hand so that
you can press the on/off button with your thumb. Turn the guide cap until the
"knife with serrated blade" symbol is in line with point b on the device.
2. Insert each individual knife blade into the guide mechanism and sharpen it on
the abrasive block (illustration 3). Then proceed as described under points 3 to
5 in the "Kitchen Knives" section.
Scissors
1. Open the blades of the scissors completely.
2. Hold the housing in your hand so that you can press the on/off button with your
thumb.
3. Turn the guide cap until the "scissors" symbol is in line with point b on the
device.
05-MSS 2990 39
Initial Operation
Sharpening
Knives with Serrated Blades
GB
39
28.07.2005, 8:41:18 Uhr