Valor Linear Serie Guide D'installation page 2

Installation
Unpack all cartons carefully, with special care for the
glass panels and the top ceramic panels.
The glass panels are maintained in place in the fi rebox
by the retainer strips and glass anchors.
To achieve the intended eff ect, the liners should be
installed so the smooth side is visible.
1. On each side at the top front of the fi rebox, remove
the existing side panels anchors and discard them.
Replace with those included with this kit.
2. Place one side panel and maintain it in place with a
side anchor provided with this kit.
3. Repeat with the other side panel.
4. On the rear of the fi rebox, at the top, back up the
four screws to install rear panel anchors. On the
1800, there are only two screws and they can be
seen through the square holes in the top rail.
1500, 1700 models
2
1800 models
5. Place the rear glass retainer strips, groove at the
back, on the ledge of the fi rebox behind the burner.
The strip are held in place with the tabs of the ledge
as indicated below.
Groove
Rear glass retainer strip—top view
6. Insert, from the center of the fi rebox, the fi rst rear
panel section - left or right - behind the top rail and
place in the groove of the retainer strip. The left sec-
tion will overhang the strip on the left. The right sec-
tion will overhang the strip on the right. The center
section straddle both strips.
Note: For 1825RGL, insert the sections from the
center of the fi rebox, upwards, behind the top rail,
then fi t them into the groove of the retainer strips
and slide them into position.
7. Insert the second section in the groove of the
retainer strips and slide it to the opposite side.
8. Insert the center section between the side sections
and place it in the groove of both retainer strips.
9. Pull back towards the center the side sections to
close any gap between them.
Rear
Front