Operating Procedures - Shizuoka Seiki Co. VAL6 MPX Manuel D'utilisation

3-2. Operating procedures

CAUTION
■ Ignition Procedures
• When switching on the heater, please make sure that the heater is ignited properly and its combustion is stable.
Use the fuel gauge to check if the fuel is
1
sufficiently filled up in the tank.
Turn "ON" the operating switch, and the
2
heater will ignite in about 5 seconds.
If ignition fails, try again as follows
Stop the operation completely. Wait for the
operating lamp to turn off. After the operat-
ing lamp has turned off, try step 2 above
again. DO NOT TRY TO IGNITE THE
HEATER MORE THAN THREE TIMES IN A
ROW AS FIRE MAY RESULT.
■ Changing combustion speed
The heater has two-step combustion and it
can be changed by change-over switch.
• If you detect smoke or a burning smell coming from the heater, turn the heater off immediate-
ly to help prevent a fire, contact your dealer and the heater inspected before further operation.
• More than three consecutive attempts to ignite the heater may cause a fire. If the heater
does not ignite after three consecutive attempts, stop trying and contact your dealer for
an inspection of the heater.
• When using the heater, be careful so that the floor surface (in front of it ) may not get overheated.
• Do not operate the heater, while fuel tank is dirty and foul, to prevent poor ignition or
improper burning.
Observations
Operating Switch "ON"
Operating Switch "OFF"
Change-over Switch
9