Operating Procedure; Preparation For The Operation - Shizuoka Seiki Co. Hot Gun 125NA Manuel D'utilisation

Operating Procedure

3
(If the heater has not been used for a long period of time, carry out the following before
using the heater.)
• Make sure that the air vent hole in the fuel tank cap is clean. If the hole is plugged it causes the flame to extinguish dur-
ing operation.
★ Cleaning the air vent hole
Insert a pin, etc., into the air vent hole to re-
move dirt.

3-1. Preparation for the Operation

■ Refueling
DANGER
CAUTION
• Make sure only kerosene or Fuel-Oil no heavier than No.2 (Diesel). Never use poor quality or foul kerosene, to have no
troubles at all.
• Never refuel the heater if the tank inlet filter is out of place. Dust or dirt can enter the tank resulting in abnormal com-
bustion or damage.
Remove the fuel cap and insert a handy
1
suction pump into the fuel tank.
Watch the fuel gauge while refueling.
2
When the gauge reaches the maximum
level, stop refueling.
8
Observations
• Never use highly volatile fuels such as gasoline, etc, to avoid fire.
• Always make sure the flame is completely extinguished before refueling the heater.
Refueling while the heater is in operation can result in fire.
• Never put more fuel in the tank than the maximum level indicated by the fuel gauge.
Fuel can spill out of the tank resulting in fire.
• If you get fuel on your skin, use soap, etc., to wash it off as soon as possible. Fuel can
cause inflammation of the skin.
Observations
Pin
Air Vent Hole
Tighten well the fuel cap, and wipe off any
3
spilt.