How To Connect The Control Device - Shizuoka Seiki Co. VAL6 MPX Manuel D'utilisation

■ Shut-Down Operation
CAUTION
• Before you disconnect the power plug from the AC outlet, please make sure that the fan motor is stopped.
• Never disconnect the power plug while the heater is operating (cooling operation), it will cause nozzle to be clogged.
Turn "OFF" the operating switch, and the
heater flame will be extinguished, then the
cooling operation will also automatically
stop after about three (3) minutes.
● If the heater is used for only a short period of time
after refueling, air inside of the fuel pipe may cause
the flame to flicker when the heater shutting down.
This is not abnormal.

3-3. How to connect the Control Device

To connect the thermostat
Take the cap off and hook up thermostat
plug (No need to rewire)
Direct-coupling pin
Don't forget to put the cap back unless the thermostat is connected to heater. Without the cap, heater won't
operate at all with all circuit cut off. Therefore, there is the direct-coupling pin inside the cap and it must
be used.
10
• After the operation is shut down, please make sure that the flame is completely extin-
guished before leaving the heater unattended or moving or storing it.
Observations
Cap
Operating Switch "OFF"
Thermostat