Publicité
Les langues disponibles
Les langues disponibles
- Do not use the machine for any other use outside the scope of this manual.
- Any other use different from that indicated in these instructions is deemed improper and may cause
damage to the machine and present a danger to the user.
- DO NOT use nor mount on the machine accessories that are not recommended by the manufacturer.
- The product is not intended for artisanal, commercial, professional and/or industrial use.
- Do not use for applications not covered in this manual.
- The manufacturer or seller cannot be held responsible for incorrect or non-compliant use of machine.
- The user / operator will be held solely responsible. The manufacturer does NOT assume any liability
for any resulting damage or accident.
5.2- Application conditions
This log splitter is a home use model.
It is designed for operating under ambient temperatures between +5°C and 40°C and for installation at
altitudes no more than 1000m above M.S.L.
The surrounding humidity should less than 50% at 40°C.
It can be stored or transported under ambient temperatures between -20°C and 55°C.
The log splitter must
be used horizontally
and never vertically!
ATTENTION! National or local regulations regarding noise may restrict the use of the machine to
certain hours or periods. Check with your local authority.
It is recommended to restrict working hours to a minimum and always take rest periods.
For proper use, after each work period take a rest period (for ex. take a rest for 10 minutes after a work
period of 60 minutes)
5.3- Before operating the log splitter
Check the oil level and refill as required before use.
1. Familiarize yourself with the controls and features of the log splitter (refer to the illustrations).
2. The Bleed Screw should be loosened by some rotations until air can go in and out of the oil tank
smoothly. Air flow through the Bleed Screw hole should be detectable during the log splitter is under
operations.
Failure to loosen the bleed screw will keep the sealed air in the hydraulic system.
The air being compressed and then decompressed, such continuous air compression
and decompression will blow out the seals of the hydraulic system and cause
permanent damage to the log splitter.
3. Before moving the log splitter, make sure the bleed screw is tightened to avoid oil leaking from this
point.
4. Plan your work site.
Work safely and save effort by planning your work beforehand.
Have your logs ready to split positioned tidily where they can be easily reached.
Have a site located to stack the split wood or load it onto a nearby vehicle, wheelbarrow or another
carrier.
5. Prepare the logs for splitting.
The log splitter can accommodate logs up to 52cm in length and with diameter (See specs table).
6. Apply a thin coat of grease to the surfaces of the cutting wedge before operation will lengthen the
durability of the wedge
7. Route the power cord.
Route the cord from the power source to the splitter in a way that safeguards against tripping on the
cord, or the cord becoming damaged during the work session.
Protect the power cord from impacts, pulling or corrosive materials.
Page 40 / 69
Publicité
