Product And Package Contents; Preliminary Warning Notices; Initial Operations, Safety Instructions - Laserworld PL-16.000RGB Mode D'emploi

Manual: Purelight PL-16.000RGB / PL-31.000RGB

1. Product and package contents

Please check if all listed parts are included and undamaged. Included in delivery:
1 x laser projector
1 x manual
1 x Allen key 4mm

2. Preliminary warning notices

1. Please use this device only according to these operating instructions.
2. Do not use the device if there are any visible damages on housing, connector panels,
power supplies or power cords.
3. Never look directly into the light source of a laser projector. Danger of damage to the
eyes or even blindness in extreme circumstances!
4. Do not operate the device at high humidity or in the rain.
5. Protect device against dripping or splashing water. Do not place any liquid filled
containers near to this device.
Any warranty claims are void if the warranty label is removed or tampered

3. Initial operations, safety instructions

1. Make sure to use correct voltage; see in-
formation on device & in this manual.
2. Make sure that the device is not connec-
ted to mains during installation.
3. Installation has to be done by technical
experienced and qualified persons ac-
cording to safety regulations of the res-
pective country.
4. Always ensure that maximum permis-
sible exposure (MPE) is not exceeded
in areas accessible to the public or
members of staff.
5. In some countries an additional
pection by technical control institutes
could be necessary.
6. The power supply should be easily acces-
sible.
page 4 / 30
1 x external PSU (16.000RGB)
1 x power cable
2 x key
with in any way.
7. When installing the laser mount it with
a minimum distance of 15 cm from walls
and objects.
8. For safe setup e.g. on walls or ceilings
please use a safety cord. The safety cord
should be able to withstand tenfold the
weight of the device. Please follow the
accident prevention regulations of pro-
fessional associations and/or comparable
regulations for accident prevention.
9. If the device has been exposed to great
temperature changes, do not switch it
on immediately. Condensation water (or
any moisture/water formed) may dama-
ins-
ge device.
10. Never use dimmer, RC or other electroni-
cally switched sockets. Whenever possib-
le, do not use the laser projector together