Télécharger Imprimer la page

FMS 1700mm PA-18 Super Cub Mode D'emploi page 12

Publicité

Les langues disponibles

Les langues disponibles

Trouble shooting
Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise or
extra vibration.
Reduced flight time or
aircraft underpowered.
Control surface does not
move, or is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.
Spare parts list content
FMSRM101
Fuselage
FMSRM102
Main wing set
FMSRM103
Horizontal stabilizer
FMSRM104
Battery hatch
FMSRM105
Wheel set
FMSRM106
Front landing gear set
FMSRM107
Supporting bar set
FMSRM108
Cowl
FMSRM109
Propeller plate
FMSRM110
Pipe
FMSRM111
Antenna
FMSRM112
LED
FMSRM113
Lamp Cover
FMSRM114
Sticker
FMSRM115
Linkage rod
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.
Possible Cause
-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
Solution
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
FMSRM116
Screw set
FMSPROP054
Propeller
FMSDZ022
Motor shaft
FMSDJ015
Motor mount
FMSBM034
Motor board
PRKV750E
Brushless motor
PRESC025
45A ESC
PR17GAP
Predator 17g analog gear servo positive
FMSSER9GPW
9g Servo(with waterproof function)
FMSCON008
Multi-connector set
FMSCHR01
Charger
FMSFLT006
Float Set
12

Publicité

loading