Bosch RH228VC Consignes De Fonctionnement/Sécurité page 8

BM 1619929E69 03-11:BM 1619929E69 03-11.qxp 3/28/11 2:03 PM Page 8
Disconnect the plug from
WARNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING SDS-plus
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
REMOVING SDS-plus
Accessories may be hot after
WARNING
use. Avoid contact with skin
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
AUxILIARy HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen
the hand grip, move the handle to the
desired position along the barrel and
securely retighten the hand grip (Fig. 4).
Assembly
®
ACCESSORIES
®
ACCESSORIES
-8-
FIG. 2
DUST
SHIELD
FIG. 3
HAND GRIP
FIG. 4
LOCKING
SLEEVE