Publicité
Les langues disponibles
Les langues disponibles
Engine warm-up
Starting a warm engine
1. Ignition switch
2. Throttle trigger
1. Choke lever
2. Cold Start
Stopping the engine
1. Ignition switch
2. Throttle trigger
3. Throttle trigger lockout
4. Start
3. Run
3. Stop
Engine operation
1.
Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2.
Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
1.
Move the ignition switch to the Start position.
2.
Make sure that the throttle trigger is at the idle speed posi-
tion.
3.
Check that the choke lever is in the "Run" position.
4.
If fuel tank is not empty, pull on the starter handle to start the
engine.
5.
If no fuel is visible in the purge bulb, alternately press and re-
lease the purge bulb until the fuel is sucked up into it.
6.
Checking that the area around you is safe and pull on the
starter handle to start the engine.
1.
Release the throttle trigger and set the engine to idling (i.e.
low speed).
2.
Move the ignition switch to the Stop position.
3.
In the event of an emergency, stop the engine immediately
using the ignition switch.
4.
If the engine fails to stop, move the choke lever to the "Cold
Start" position. The engine will stall and come to a halt (a
choke stop).
∗ If the engine fails to stop when the ignition switch is used, have
the ignition switch checked and repaired by your dealer before
you use the product again.
The cutting attachment can continue moving after the
engine is stopped.
21
WARNING
Publicité
