Publicité
Les langues disponibles
Les langues disponibles
Before you start
1. Throttle cable
2. Adjustment fixture
3. Throttle swivel hole
4. Adjustment nut
5. Locknut
1. Ignition leads
1. Ignition leads
2. Clip
3. Fan cover clip
2.
Place throttle cable into adjustment fixture and install wire
end into large carburettor throttle swivel hole.
3.
The throttle lever free play should be approximately 4-6 mm.
4.
Turn the adjustment nut in or out as required to obtain proper
free play 4-6 mm.
5.
Make sure that the throttle lever operates smoothly without
binding.
6.
Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly.
7.
Tighten locknut.
8.
Connect 2 ignition leads from throttle cable tubing to 2 igni-
tion leads on engine.
9.
Secure ignition leads against engine with clip.
10. Install throttle cable into fan cover clip.
11. Install air cleaner cover.
Wiring runs must not interfere with throttle operation.
16
CAUTION
Publicité
