Télécharger Imprimer la page

Miller Spoolmate 250 Manuel Du Propriétaire page 15

Publicité

2-4. Installing Wire Spool And Threading Welding Wire
Tools Needed:
5
9
10
Press gun trigger to feed wire to check drive roll
pressure. Turn screw enough to prevent slipping.
7
6
8
3
Remove nozzle and contact tip. Push
and hold red lever. Thread wire through
inlet guide, past push roll/drive roll, and
out end of gun 2 inches (50 mm).
Install contact tip and nozzle. Reinstall
spool cover and thumb screw.
.
Screw rotation clockwise decreases
drive roll pressure and counterclockwise
rotation increases pressure.
Wood
1
Thumb Screw
2
Spool Cover
Remove thumb screw and spool
cover.
3
Hub Tension Nut
4
Wire Spool
Install spool so wire feeds from top.
Turn hub tension nut just so a slight
4
drag is felt on the wire spool.
5
Push Roll/Lower Drive Roll
2
6
Drive Roll Pressure
Adjustment Opening
7
Drive Roll Release Lever
1
(Red)
8
Wire Inlet Guide
9
Contact Tip
10 Nozzle
Release red lever.
Turn On welding
power source power.
Cut off wire.
Ref. 802 576
OM-1215 Page 11

Publicité

loading