Güde P 2500 Mode D'emploi page 14

Assembly
The saw-chain grinding machine is delivered pre-assembled. One part consists
of the base, on which the chain guide is located. The other part is a bearing arm
with the motor and handgrip.
The assembly shall be performed with the machine unplugged!
The machine design provides either for a desk installation or wall mounting.
When installing it on the desk, put the machine on the edge of the desk to the
1
stop (Fig. 1) and screw it to the desk using the holes in the base.
When mounting on the wall, use the respective holes in the vertical part of the
base (here, a distance from the wall should be kept or spacers should be used
for the access to the rear set screw to be preserved).
After the desk top installation, fit the arm in the base inserting the pilot pin and
securing it with a hexagonal screw (Fig.2)
Now, it is possible to fit a washer on the rear side screw and screw the setting
and screw the setting wheel on. (Fig. 3).
Screw the supporting arm control holder on the screw in the grinding disk body
(Fig.4)
Fit the grinding disk enclosure on using the supplied screws and a respective
wrench (Fig. 5).
2
Tip:
When mounting on the wall, take care to mount the machine at a height of
120 – 130 cm from the floor to avoid working at eye height!
To be able to install the disk, it is necessary to unscrew the auxiliary flange (Fig.
6).
3
4
5
6
14