Télécharger Imprimer la page

Becker Centronic EC711 Notice De Montage Et D'utilisation page 59

Publicité

Les langues disponibles

Les langues disponibles

Deleting the programming run on B-Tronic radio
receivers
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
All the following settings will then only be executed for this device.
5s
Intermediate positions/tilt positions
The intermediate positions or tilt positions are freely select-
able positions for the shading solution or blind between the
two limit positions. Each travel button can be assigned one
intermediate position/tilt position. Both limit positions must
be set before an intermediate position is set.
When both or individual limit positions are deleted, both in-
termediate positions/tilt positions are deleted as well.
With external receivers it is possible to overwrite in any posi-
tion without deleting the previous position.
Press the programming button and, within 1
second, also press the DOWN button and hold the
two buttons down.
▻ The receiver confirms.
► The programming run is completed.
button until the required receiver con-
Open/close the shading solution to a point
between the limit positions.
Press the programming button and, within the
next 1 second, press the STOP button at the same
time and hold the two buttons down for 5 seconds.
▻ The receiver confirms.
► The programming run is now deleted.
59 - en

Publicité

loading

Ce manuel est également adapté pour:

B-tronic easycontrol ec711