Becker Centronic EC711 Notice De Montage Et D'utilisation page 53

Changing the direction of rotation of B-Tronic
products
Check the direction of rotation before setting the limit positions. The shading
solution must move in the correct direction when the UP or DOWN buttons are
pressed.
If this is not the case, please carry out the following steps to change the direc-
tion of rotation:
No limit positions must be programmed. Delete the limit positions if neces-
sary.
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
3s
button until the desired receiver con-
First press the programming button and, within
the next 3 seconds, press both the UP and DOWN
buttons for 3 seconds.
▻ The receiver confirms.
Check the running direction again.
53 - en