Kenwood FPM260 Serie Manuel D'instructions page 6

to use your food processor
1 Fit the bowl by aligning the
power unit, turn clockwise
2 Fit an attachment over the bowl drive shaft.
Note: Detachable drive shaft
when using the discs, citrus juicer or twin beater
geared metal whisk.
Always fit the bowl and attachment onto the processor before
G
adding ingredients.
3 Fit the lid - ensuring the top of the drive shaft/tool locates into
the centre of the lid.
Do not use the lid to operate the processor, always
G
use the on/off speed control.
4 Plug in, switch on and select a speed. (Refer to the
recommended speed chart).
The processor will not operate if the bowl or lid are
G
not fitted correctly into the interlock. Check that the
feed tube and bowl handle are situated to the right
hand side.
Use the pulse (P) for short bursts. The pulse will operate for as
G
long as the control is held in position.
5 Reverse the above procedure to remove the lid, attachments and
bowl.
Always switch off and unplug before removing the lid.
G
important
Your processor is not suitable for crushing or grinding coffee
G
beans, or converting granulated sugar to caster sugar.
When adding almond essence or flavouring to mixtures avoid
G
contact with the plastic as this may result in permanent marking.
to use your liquidiser
1 Fit the sealing ring into the blade unit
located correctly in the grooved area.
Leaking will occur if the seal is damaged or
G
incorrectly fitted.
2 Screw the goblet onto the blade assembly
graphics on the underside of the blade unit as follows:
- unlocked position
- locked position
The liquidiser will not operate if incorrectly
assembled.
3 Put your ingredients into the goblet.
4 Fit the lid to the goblet and push down to secure
filler cap.
5 Place the liquidiser onto the power unit, align the
liquidiser with the on the power unit and turn
clockwise to lock .
The appliance will not operate if the liquidiser is
G
incorrectly fitted to the interlock.
6 Select a speed (refer to the recommended speed chart) or use
the pulse control.
on the bowl with the on the
until it locks .
should only be fitted
- ensuring the seal is
. Refer to the
. Fit the
on the
safety
Liquids should be allowed to cool to room
G
temperature before blending.
Always take care when handling the blade assembly and avoid
G
touching the cutting edge of the blades when cleaning.
G Only operate the liquidiser with the lid in place.
Only use the goblet with the blade assembly supplied.
G
Never run the liquidiser empty.
G
To ensure the long life of your liquidiser, do not run it for longer
G
than 60 seconds.
Smoothie recipes - never blend frozen ingredients that have
G
formed a solid mass during freezing, break it up before adding to
the goblet.
hints
When making mayonnaise, put all the ingredients, except the oil,
G
into the liquidiser. Remove the filler cap. Then, with the appliance
running, add the oil slowly through the hole in the lid.
Thick mixtures, e.g. pâtés and dips, may need scraping down. If
G
the mixture is difficult to process, add more liquid.
Ice crushing - operate the pulse in short bursts until crushed to the
G
desired consistency.
The processing of spices is not recommended as they may
G
damage the plastic parts.
The appliance will not work if the liquidiser is incorrectly fitted.
G
To blend dry ingredients - cut into pieces, remove the filler cap,
G
then with the appliance running, drop the pieces down one by
one. Keep your hand over the opening. For best results empty
regularly.
Don't use the liquidiser as a storage container. Keep it empty
G
before and after use.
Never blend more than 1.2 litres - less for frothy liquids like
G
milkshakes.
3