Publicité
Les langues disponibles
Les langues disponibles
•
If Redmax two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION:
oil for water-cooled outboard engines,
also referred to as outboard oil. Do not
use oil for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION:
the ratio of the mixture drastically when you
mix small quantities of fuel. Measure the
quantity of oil carefully and make sure that
you get the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
8
Do not use two-stroke
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
US fl. oz.
2 ½
6 ½
12 ⅞
Small errors can influence
CAUTION:
than 1 month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Remove the fuel tank cap and fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to
To install the leaf catcher and the blade
tip protection
1. Remove the outer 8 nuts from the bolts on the blade.
2. Put the leaf catcher on the 8 bolts. Refer to
overview on page 2 , to see where the leaf catcher is
on the product.
3. Put the blade tip protection on the 2 bolts on the tip
of the blade.
4. Install the 8 nuts to the bolts.
5. Torque the nuts to 7 Nm.
To start the product with a cold engine
1. Pull the choke control to choke position.
Do not mix fuel for more
Product
1075 - 004 -
Publicité
