Broan best KEX222 Mode D'emploi page 7

All manuals and user guides at all-guides.com
HOW TO ASSEMBLE THE
LADLE BAR
The side ladle bars must be assembled before
installing the hood against the wall.
To assemble the side ladle -bars follow the
instructions below:
1. Take off the two end bits of the ladle bar
slackening screws B. Insert the side ladle
bars where the end bits were and fix them
by means of screws B.
2. Insert the fixing element M into the side ladle
bar and fix it tightening screw C.
3. To fix definitively the M element onto the
hood, it is necessary to have access from
the inside of the hood:
- remove the grease filters: at the handle,
push the stop inwards and pull the filters
downwards.
- take off the lower part of the hood
unscrewing the two screws A. The lower part
of the hood must not be completely taken
off, but it must be bent slightly until the
screwdriver can have access. Fix element
M to the hood from the inside, by means of
mounting screws (M8x14mm).
4. Reassemble the lower part of the hood.
IN-LINE BLOWER
B
END BITS
- 7 -
C
M
B
LADLE BAR
A
A
LOWER PART OF
THE HOOD