Publicité
Les langues disponibles
Les langues disponibles
10.Forheavily soiledareas,itmay
be necessary t o repeat t hecleaning
process. M akecrisscrossing s trokes
totheoriginal p attern; o verlap each
pass.
Make no more than 2 passes with
the solution over any one area to
prevent over=wetting
and damage
to fabric.
If additional cleaning is necessary,
wait until the upholstery is complete-
ly dry before using the tool again.
11. Empty recovery tank when the
motor sound becomes higher
pitched and there is a loss in suction
(see "Automatic shut-off", page 8).
When finished cleaning, follow "After
cleaning" instructions on pages 10
and 11 and "After using tool" instruc-
tions on pages 13 and 14.
Removab|e
brushes
Your carpet cleaner is equipped
with removable brushes for easy
cleaning.
To remove
brushes
Disconnect cleaner from electrical
outlet.
To prevent possible leaking, remove
clean solution tank and recovery
tank. Set tanks aside.
Press handle release pedal to lower
handle. Turn cleaner over so bottom
is facing up.
Grasp inner portion of brush (A) and
pull brush assembly out slightly to
reveal latches (B).
Press all four latches (B) and pull
brush block out. The brushes can
be cleaned under running water.
C
To replace
brushes
Align posts (C) on both ends of
brush assembly with slots (D) in
cleaner housing.
Make sure that square post (E) also
aligns with square hole (F). Turn
brushes slightly until post fits easily
into hole.
.................
_L_TS_J
Press brush assembly firmly to snap
into place.
Continued
-_
15
Publicité
