ELECTRONICOVENCONTROL
A
B
C
D
E
ii
ii
©
OVEN
LIGHT
Q
CLOCK
®
TIMER
Timer
....... oFF
TEMP/HOUR
I
H
G
A. Oven light
F. Temp/Hour
B. Clock
G. Broil
C. Display
H. Bake
D. Start (control lock)
I. Timer
E. Off/Cancel
F
When power is first supplied to the appliance, a flashing time will
appear on the display. Press OFF/CANCEL to clear flashing time
from the display.
If flashing time appears, a power failure has occurred. Press
OFF/CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a cook or timer function, the display will show
either hours and minutes, or minutes and seconds.
The indicator lights are located on both sides of the display. The
indicator lights light up or flash when the oven is in one of the
following modes: Bake, Broil or Timer.
The START pad begins any oven function. If the START pad is not
pressed within 5 seconds after pressing a function pad, the Push
to Start ("PSH') indicator light will flash and the push to start tone
will sound as a reminder.
If the START pad is not pressed within 1 minute after pressing a
function pad, the oven display will return to the time of day mode
and the programmed
function will be canceled.
The OFF/CANCEL pad stops any function except the Clock,
Timer and Control Lock.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Press the TEMP/HOUR "up" or "down" arrow pads to set the
time of day.
3. Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
[]
Valid pad press
[]
Oven is preheated (long tone)
[]
Function has been entered
Three tones
[]
Invalid pad press
[]
Push to start reminder
Cycling
tones
[]
End of cycle
The temperature
is preset at Fahrenheit, but can be changed to
Celsius.
To Change:
Press and hold BROIL for 5 seconds. A tone will
sound, and "C" will appear on the display. Repeat to change
back to Fahrenheit. To exit mode, press OFF/CANCEL
8