Something Not Working - Fust NOVAMATIC FH66-412K Notice D'utilisation

72
To replace the faulty bulb.
1. Turn the glass cover anticlockwise and
remove.
2. Remove the faulty bulb and replace
with a new one.
3. Refit the glass cover.
Reconnect the appliance to the electricity
supply.

Something not working

If the appliance is not working correctly, please carry out the following checks, before
contacting your local Electrolux Service Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Symptoms
The hob hotplate does not heat up
The hotplate is not giving satisfactory results
The oven does not come on
It takes too long to finish the dishes, or they
are cooked too fast
Steam and condensation settle on the food
and the oven cavity
Solutions
Check:
that the unit is connected and the
-
electrical supply is switched on
- the mains fuse has not blown
the correct control knob has been
-
turned.
Check:
the hotplate is clean and dry
-
the pan is the correct size for the
-
hotplate
the pan has a flat bottom
-
- the setting is correct for the type of
cooking.
Check:
check if a cooking function/temperature
-
has been selected correctly
the socket switch or the switch from the
-
mains supply to the cooker are ON.
Check:
the temperature may need adjusting
-
refer to the contents of this booklet,
-
especially to the chapter "Using the
Oven".
Leave dishes inside the oven no longer
-
than 15-20 minutes after the cooking is
completed.