Electrical Connections - Fust NOVAMATIC FH66-412K Notice D'utilisation

Electrical connections

Any electrical work required to install
this hob and the supply cable should be
carried out by a qualified electrician or
competent person, in accordance with the
current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
Before any maintenance or cleaning
can be carried out, you must DISCONNECT
the cooker from the electricity supply.
This cooker is designed to be connected to
230/400V 3N ~ electrical supply for
appliances with heating elements voltage of
230V, and 400V 3 ~ (400V 2 ~ ) electrical
supply for appliances with heating elements
voltage of 400V.
To connect to the electricity supply, use cable
type H05 RR-F.
Before switching on, make sure the
electricity supply voltage is the same as that
indicated on the rating plate.
The cooker is supplied without supply cord.
The connection options for the
cooker are shown on the plate (wiring
diagram) on the rear of the cooker.
In case of a direct connection to the mains
you have to interpose an omnipolar switch a
minimum opening between contacts of 3
mm.
The switch should be sited within 2m of the
hob and be easily
completion of the installation.
The yellow-green grounding cable has not to
be interrupted by the switch.
NOTE: The earth wire should be about 2 cm
longer than the live and neutral wires.
accessible upon
Ensure that the cooker supply cable
does not come into contact with any part of
the hatched area shown in the diagram.
If the supply cord is damaged, the
manufacturer or its service agent or a
similarly qualified person must replace it in
order to avoid a hazard.
Before connecting check that:
•
fuse and household electric installation
can bear the charge of the appliance
(see rating plate);
•
The socket or the omnipolar switch
used for connection is easily reachable
when the appliance is installed.
How to proceed?
•
Unscrew and remove the protective
cover at the back of the appliance;
•
Connect the power cord to the
terminal of the cooker according to
the label on the back of the appliance.
•
Fix by means of cable clamp;
•
Make sure that the connection to the
terminal is matching the network
power;
Remount and screw the protective cover
at the back of the appliance
61
supply
cable