Oven Bulb Replacement - Fust NOVAMATIC FH66-412K Notice D'utilisation

The Hob Top
The hob is best cleaned whilst it is still
warm; as spillage can be removed more
easily than if it is left to cool.
Regularly wipe over the hob top using a soft
cloth well wrung out in warm water to which
a little washing up liquid has been added.
Avoid the use of the following:
•
household detergent and bleaches;
•
impregnated pads unsuitable for non-stick
saucepans;
•
steel wool pads;
•
bath/sink stain removers.
The Hotplates
Spills onto the actual plate should be removed
using warm water and a soft brush, nylon or
plastic scourer. To keep the plates looking as
new, hotplate conditioner can be purchased
from most hardware stores, e.g. "4 Hob" by
HomeCare Products
manufacturer's instruction for use).
Alternatively, wipe the plates with a drop of
olive oil on a kitchen towel to avoid rust. It
is important to note that the plate will
smoke a little and produce a slightly
unpleasant odour when next used.
Drying
Important: After cleaning, dry the hotplates
thoroughly by switching on to a low-
medium setting for a few minutes.

Oven bulb replacement

Ensure that the appliance is switched
off and disconnected from the electricity
supply before replacing the bulb to avoid
possibility of an electric shock.
If the oven bulb needs replacing, it must
comply with the following specifications:
(follow the
Restoring
To maintain the appearance of your
sealed hotplates apply a little salt-free
vegetable oil or
periodically.
To apply vegetable oil
on a medium setting for 30 seconds then
turn off. Pour a very small amount of salt-
free oil onto a dry cloth or kitchen paper.
Apply a thin coat of oil to the hotplate
surface and wipe off any excess. Heat the
hotplate on a medium setting for 1 minute.
To apply restorative agent: first heat the
hotplate on a medium setting for 30
seconds then turn off. Apply a very thin
coating of Collo Electrol (using the
applicator). Heat a hotplate on a high
setting for 2-3 minutes to cure. Some
smoke will occur, this is normal and
nontoxic. (NB: this product is a restorative
agent not a cleanser. It is available from
hardware stores).
Stainless steel parts: the stainless steel spill
rings may become straw coloured with use.
Use a proprietary stainless steel cleaner to
remove this straw discolouration. This also
applies to the area around the hotplates on
stainless steel hobs.
Electric Power: ...........................25W
Electric Rate:...............230/240V(50Hz)
Resistant to temperatures of:.......300ºC
Connection Type: ........................E14
restorative agent
:
first heat the hotplate
71