Télécharger Imprimer la page

Moen MOTIONSENSE WAVE 5923EWBL Manuel D'installation page 16

Publicité

A1
Low Flow/Flujo bajo/Faible débit
If low flow, turn off water at stops before cleaning filters.
Si el flujo es bajo, cierre el agua en los topes de cierre antes
de limpiar los filtros.
Si le débit est faible, couper l'alimentation en eau aux
robinets d'arrêt avant de nettoyer les filtres.
A4
V
Use needle nose pliers to remove Filter Screen (V).
Use needle nose pliers to remove Filter Screen (V).
Use needle nose pliers to remove Filter Screen (V).
A2
3
1. Turn water off.
2. Disconnect supply lines.
3. Remove supply lines.
1. Cierre el agua.
2. Desconecte las líneas de suministro.
3. Retire las líneas de suministro.
1. Couper l'alimentation en eau.
2. Débrancher les conduites d'alimentation.
3. Enlever les conduites d'alimentation.
A5
1
V
2
2
45
1. Insert each Filter Screen (V) into a cup of water.
2. Agitate filter hoses back and forth for 15 seconds to
remove any possible debris. Remove Filter Screen (V)
from cup and drain.
1. Insert each Filter Screen (V) into a cup of water.
2. Agitate filter hoses back and forth for 15 seconds to
remove any possible debris. Remove Filter Screen (V)
from cup and drain.
1. Insert each Filter Screen (V) into a cup of water.
2. Agitate filter hoses back and forth for 15 seconds to
remove any possible debris. Remove Filter Screen (V)
from cup and drain.
16
A3
1. Insert each filter hose into a cup of water.
2. Agitate filter hoses back and forth for 15 seconds to
remove any possible debris. Remove filter hoses from
cup and drain.
Note: Filter screen (U) can be removed for further cleaning.
Screen must
be reinstalled to maintain product warranty.
1. Inserte cada manguera con filtro en una taza de agua.
2. Agite las mangueras con filtro durante 15 segundos
para retirar cualquier basura posible. Retire las
mangueras con filtro de la taza
y escúrralas.
Nota: El filtro (U) puede ser retirado para una mejor
limpieza. Debe volver a instalarse para mantener
vigente la garantía del producto.
1. Immerger chacun des tuyaux avec filtre dans une
tasse d'eau.
2. Le remuer dans l'eau pendant 15 secondes pour en
éliminer tous débris possibles. Retirer les tuyaux
filtrants du contenant, puis en laisser égoutter l' e au.
Remarque : Le filtre (U) peut être enlevé pour nettoyer le
tuyau de manière plus approfondie. Il doit être remis
en place afin que le produit conserve sa garantie.
0 0
15
Sec.
30
1
2
2
0 0
15
45
Sec.
30

Publicité

loading

Ce manuel est également adapté pour:

Motionsense wave m5923ewbl