FUAVE ACB07Z22 Manuel D'instructions page 29

Mode
With this you select a particular function: automatic, cooling, fanning or
dehumidifying� Every time you press the button, you change the function;
the light on the control panel shows which function is active� The fan is
set automatically�
Cooling
Press the Mode button until the function light 'Cool' comes on, press the
+ and – buttons to set the desired room temperature (17°C – 31°C)� Using
the FAN SPEED button on the remote control, you can set the fan speed to
HIGH or to LOW�
Fanning
Press on the Mode button until the 'Fan" function light comes on� Using
the FAN SPEED button on the remote control, you can set the fan speed to
HIGH or to LOW� The temperature cannot be set�
Ontvochtigen
Press on the Mode button until the "Dry" function light comes on� The fan
speed and temperature cannot be set� The fan starts automatically on
LOW speed�
Timer/Temperature
With this, you set the desired room temperature in steps of 1°C (from 17°C
to 31°C)� The control system can show temperatures in °C and in °F� If the
temperature is shown is °F, then press both + and – buttons at the same
time for 3 seconds and the temperature will show °C again�
26