Table des Matières
Publicité
2.2 -
POSITIONING
Position the pallet, with the slicer, on a
flat surface and take off (a) the sharpe-
ner from the slicer (Fig. n°12).
At this point turn the machine on its
side (Fig. n°13) and unscrew, with the
proper wrench provided, the 4 nuts
which fasten the slicer. Remove the 4
washers and unscrew the 4 fastening
tie rods on the wooden pallet. Take off
the pallet and fasten the 4 feet provi-
ded. Finally, put the sharpener in its
place.
Position the slicer in the predestined
place.
The dimensions indicated in Tab. 1
(according to the model) must be kept
in mind for the plane where the slicer
will be installed, therefore it must be
wide enough, well-levelled, dry, smo-
oth, robust, stable about 80 cm high off
the ground and at least 20 cm from
walls, objects, shelves, etc. (Fig. n°14)
in respect to the space necessary for
its use and safeguarding.
Furthermore the machine must be pla-
ced in an environment with a maximum
humidity of 75%, not salty and with a
temperature between +5°C and +35°C;
in any case in environments which do
not lead to deviations of the above.
Make sure the graduated handgrip is in
posiion "0".
Check the alignment of the blade-plane
thickness gauge by running a finger
(Fig. n°16) from the blade towards the
thickness gauge plane (never in the op-
posite direction). Unscrew and screw
the foot (1) until the correct alignment is
found (Fig. n°17), then screw the rub-
ber part (2) to fix everything (Fig. n°17).
Fig. n°12
Fig. n°13
20cm
20cm
20cm
20cm
~ 80cm
Fig. n°14
Fig. n°15
Fig. n°16
Fig. n°17
8
6.2 -
NETTOYAGE DE LA MACHINE
6.2.1 - Nettoyage du plateau porte-
aliments
Le chariot (plateau + bras + dispositif
d'affûtage) est facilement amovible:
Placer le bouton gradué sur la
-
position "0" (1 Fig. n°46);
Placer le chariot (2) en fin de course
-
(a) du côté des commandes; dévisser
partiellement le pommeau de blocage
plateau (3), tirer le chariot vers
l'opérateur avec une certain effort;
dévisser complètement le bouton de
blocage plateau, ensuite soulever le
chariot (4) vers le haut (b Fig. n°46);
Après avoir enlevé le chariot, on peut
-
nettoyer soigneusement le plateau
avec de l'eau tiède et le produit en
dotation ou un détergent neutre (pH
7) Fig. n°47.
1
2
b
1
a
Fig. n°46
pH
Fig. n°47
23
3
Publicité
Table des Matières
